Hubbell LightHawk LHIR Manuel d'utilisateur télécharger pdf

Description

 e LightHAWK is an intelligent self-adapting occupancy sensor that is

designed to replace existing wall switches.

Speciﬁ cations

• 1000 sq. ft coverage area (Models: LHIR and LHMT)

• 400 sq. ft. coverage area (Models: LHUS)

• Single or Dual circuit 120/277VAC, 50/60Hz operation

• Electrical Ratings: (Each Output Separately)

120VAC – 800W Incandescent, 1000W Ballast, 1/6 HP

277VAC – 1800W Ballast, 1/6 HP

• Adjustable Time Delay: 4-30 minutes, self-adapts based

on occupancy

• Light Level Adjustment (Circuit B output on Dual Circuit versions):

10-500+FC

• ETL listed (Conforms to UL STD 508 Certiﬁ ed to CAN/CSA STD

C22.2 No. 14)

Precautions

CAUTION: RISK OF ELECTRICAL SHOCK. Turn power oﬀ at

service panel before beginning installation. Never wire energized electrical

components.

Read and understand all instructions before beginning installation.

NOTICE: For installation by a licensed electrician in accordance with

National and/or local Electrical Codes and the following instructions.

NOTICE: For indoor use only.

CAUTION: USE COPPER CONDUCTOR ONLY.

Conﬁ rm that device ratings are suitable for application prior to installation.

NOTICE: Do not install if any damage to product is noticed.

Installation

1. Turn power oﬀ at the service panel.

2. Remove the old switch(es) if applicable.

3. Wire as shown in the Wiring Diagram section. A secure connection

to ground is necessary for the sensor to function properly.

4. Install sensor in wall box using mounting screws provided.

5. Restore power to the sensor and allow it to warm up (up to 2 min.).

6. Remove the sensor’s cover – see Adjustments section.

7. If desired, calibrate the photocell sensor and adjust the sensor’s

conﬁ guration switch settings as described below.

8. Reinstall the sensor’s cover.

9. Install a Decorator style wall plate (not included).

Test Mode – to enter test mode:

1. Make sure lights are on.

LightHawk

™

Wall Switch Occupancy Sensors

Installation and Operating Instructions

Hubbell Building Automation, Inc.

9601 Dessau Road, Building One, Suite 100

Austin, Texas 78754

512-450-1100 • 512-450-1215 Fax

www.hubbell-automation.com

Wiring Diagram

Sensor Operation

Range Diagram

1 2

LightHawk 1

Résumé du contenu

Page 1 - LightHawk

Description e LightHAWK is an intelligent self-adapting occupancy sensor that is designed to replace existing wall switches. Speciﬁ cations • 1000

Page 2

2. Press and hold the ON/OFF button until the lights cycle oﬀ then back on. For dual circuit sensors, press and hold the ON/OFF button for Circ

Commentaires sur ces manuels

Pas de commentaire

Hubbell LightHawk LHIR Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Non Hubbell LightHawk LHIR. Hubbell LightHawk LHIR User's Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Non Hubbell LightHawk LHIR